Tools and materials:
* Wrench set
* Ratchet
* Wrench extensions
* Jack
* Stands
* New front engine mount
Procedure:
1. Preparation:
* Disconnect the negative terminal of the battery.
* Put the car in park and apply the parking brake.
* Raise the front of the car using a jack and install stands.
2. Removing the old support:
* Locate the front engine mount (located next to the right wheel).
* Disconnect the electrical connector (if equipped).
* Remove the bolts or nuts securing the support to the frame and engine.
* Remove the support.
3. Installation of a new support:
* Place the new support in its place.
* Tighten the bolts or nuts, first by hand and then with a wrench.
*Tightening torque can be found in the vehicle service manual.
4. Installation of other components:
* Connect the electrical connector (if equipped).
* Lower the car from the jack.
5. Check:
* Start the engine and check for any vibration or noise.
* Check that all bolts and nuts are securely tightened.
Adviсe:
* Be careful not to overtighten bolts or nuts.
*If you are unsure about any part of the process, seek professional help.
*Please note that specific steps may vary slightly depending on the model and year of your vehicle.