Adaptation of PowerShift automatic transmission for Ford Focus 3
Required tools:
* Ford VCM II diagnostic scanner or similar
* Laptop
Adaptation procedure:
1. Preparation:
* Make sure the vehicle is on a level surface and in park mode.
* Stop the engine.
* Connect the diagnostic scanner to the vehicle’s OBD-II connector.
*Run diagnostic software on your laptop.
2. Reading fault codes:
* Select the ‘Transmission’ module in the diagnostic software.
* Read fault codes. If there are any codes, resolve them before continuing.
3. Adhesion point adaptation:
* Select the function ‘Adjustment of adhesion point’ in the diagnostic software.
*Follow the on-screen instructions to complete the onboarding procedure.
*This procedure adjusts the clutch point to ensure smooth shifting.
4. Adaptation of working pressure:
* Select the ‘Work pressure adaptation’ function in the diagnostic software.
*Follow the on-screen instructions to complete the onboarding procedure.
* This procedure adjusts the operating pressure in the transmission system, optimizing its performance.
5. Completion:
* After adaptation is completed, turn off the ignition and turn off the diagnostic scanner.
* Start the engine and check if the gear shifts smoothly.
Note:
* It is recommended to adapt the PowerShift automatic transmission after replacing the clutch or servicing the transmission.
*If adaptation does not resolve shifting problems, contact a qualified mechanic for diagnosis and repair.