Required tools and materials:
* Box with machine guns
* Wires (of sufficient cross-section, according to the specifications of the machines)
* Terminals or connectors
* Screwdriver or screwdriver
* Hex key set (if possible)
Connection steps:
1. Determining the location of machines
* Determine how many machines you need and arrange them in the box.
* Make sure you have enough space for wires and connections.
2. Determination of incoming and outgoing wires
* Identify the incoming wires (from the power source) and the outgoing wires (to the loads).
* Label or label the wires to avoid confusion.
3. Connecting the input cable to the machines
* Connect the input cable to the busbar at the top of the machines.
* Use appropriate terminals or connectors for reliable connection.
4. Connecting outgoing cables to machines
* Connect the outgoing cables to the bus at the bottom of the machines.
* Use appropriate terminals or connectors for reliable connection.
5. Zero bus connection
* Make sure that the machine box has a zero tire.
* Connect all neutral wires to the neutral bus.
6. Connecting the ground wire
* Make sure that the box with machines has a grounding bus.
* Connect all ground wires to the ground bus.
7. Checking connections
*Check all connections carefully to ensure they are secure and there are no exposed wires.
8. Closing the lid
* After completing the connection, close the cover of the machine box and tighten the screws.
Precautions:
* Make sure the power is turned off before doing any wiring work.
* Use the correct tools and materials.
* Comply with all applicable electrical codes.
*If you are unsure of your abilities, seek assistance from a qualified electrician.