Tools and materials:
* New oil seal for the right automatic transmission drive
* Hexagon screwdriver (Torx)
* 30 mm wrench
* Mounting blade
* Brake cleaner
* Lubrication
* Gloves
Procedure:
1. Secure the vehicle: Place the vehicle on a level surface, apply the parking brake and place wheel chocks.
2. Remove the wheel: Using a 30mm wrench, loosen the wheel bolts. Raise the car with a jack and unscrew the bolts completely. Remove the wheel.
3. Remove the mudguard: Remove the several screws holding the mudguard in place using an Allen screwdriver. Remove the mudguard.
4. Remove Drive Shaft: Using a pry bar, pry and remove the outer drive shaft from the differential. Pull the drive shaft out.
5. Remove the old seal: Using a screwdriver, carefully pry and remove the old seal from the transmission housing.
6. Clean the seat: Clean the oil seal seat of dirt and old sealant using brake cleaner.
7. Install the new oil seal: Apply a small amount of lubricant to the outer surface of the new oil seal. Carefully install the oil seal into the seat. Use a small hammer and driver to tap the seal into place.
8. Reinstall the drive shaft: Lubricate the drive shaft spline. Insert the drive shaft into the differential. Place the old or new lock washer onto the drive shaft.
9. Install the mudguard: Reinstall the mudguard and tighten the screws.
10. Install the wheel: Reinstall the wheel and tighten the bolts. Lower the vehicle from the jack and tighten the wheel bolts completely.
11. Check the oil level in the automatic transmission: Add oil to the automatic transmission if necessary.
Adviсe:
* Use only original or high quality oil seals.
* When replacing the oil seal, it is recommended to also change the oil in the automatic transmission.
* Be careful when using the paddle to avoid damaging the inside of the transmission.