Required materials:
* LEDs (preferably with maximum brightness)
* Resistors (selected depending on the LEDs used)
* Wires
* Glue or double-sided tape
Installation instructions:
1. Locate the transmission: Locate the transmission under the center console.
2. Remove the center console: The center console is usually secured with screws or latches. Carefully remove it, being careful not to damage it.
3. Remove the transmission link: Locate the shift mechanism and disconnect the link that connects the shift lever to the transmission.
4. Prepare the LEDs and resistors: Cut the wires to the required length and attach the LEDs with the corresponding resistors. Make sure the polarity of the LEDs is correct.
5. Install the LEDs: Attach the LEDs to the desired locations using glue or double-sided tape. It is advisable to position them so that they illuminate the area around the gear lever.
6. Check the connections: Connect the LEDs to a power source (such as the power terminals on the back of the cigarette lighter) and check if they light up correctly. Adjust the connection if necessary.
7. Reassemble everything: Install the transmission rocker, center console and screws.
Adviсe:
* To distribute light evenly, you can use a strip of LEDs instead of individual LEDs.
*Adjust the brightness of the LEDs using resistors so that they are not too bright or too dim.
* Make sure all connections are secure and insulated to prevent short circuits.