Materials:
* Autostart StarLine
* Keychain
* Instructions for autorun
Connection:
1. Disconnect the negative terminal of the battery for safety.
2. Install the autostart control unit in a suitable location in the vehicle.
3. Connect the wires according to the autostart manufacturer’s instructions.
4. Connect the power leads (red and black) to the corresponding battery terminals.
5. Connect the ignition wires (white and yellow) to the vehicle’s ignition wire.
6. Connect the starter wires (green and yellow) to the starter terminals.
7. Connect the neutral/park wires (orange and purple) to the neutral/park wire on the transmission.
8. Connect the antenna to the control unit.
Setting:
1. Program autostart according to the manufacturer’s instructions. This is usually done using a key fob.
2. Configure autostart parameters, such as startup time and temperature, run time, etc.
Usage:
1. Place the gear shift lever in park or neutral.
2. Remove the key from the ignition switch.
3. Press and hold the auto start button on the key fob until the beep sounds.
4. Release the auto start button and close the machine.
Auto start based on temperature:
1. Set the desired startup temperature in the autostart settings.
2. If the temperature inside the car drops below the set temperature, autostart will start the engine.
Autostart by time:
1. Set the desired startup time in the autorun settings.
2. Autostart will start the engine at the specified time.
Adviсe:
*Before installing autostart, make sure your car is compatible with it.
* Carefully follow the manufacturer’s instructions to avoid possible connection errors.
* Check and maintain your autostart regularly to ensure trouble-free operation.
* Do not leave children or animals in the car with the engine running.