What to do if the automatic transmission torque converter oil seal leaks:
1. Locate the leak. To do this, you need to inspect the gearbox and determine where the oil is leaking from. Typically the torque converter seal is located at the front of the transmission where it connects to the engine.
2. Check the oil level in the automatic transmission. An oil leak can result in low oil levels, which can damage the transmission. Check the oil level according to the instructions in your vehicle’s owner’s manual.
3. Don’t put off repairs. A torque converter seal leak will worsen over time, causing further oil leakage and potential damage to the automatic transmission.
4. Contact a qualified mechanic. Repairing a leaking torque converter seal is a complex task and requires specialized knowledge and tools. Do not attempt repairs yourself unless you have the appropriate skills and equipment.
Repair process:
1. Remove the gearbox. This is necessary to access the torque converter oil seal.
2. Separate the torque converter from the gearbox. This may require special equipment.
3. Remove the old oil seal. Be careful not to damage the sealing surface.
4. Install a new oil seal. Make sure the seal is installed correctly and facing the correct direction.
5. Assemble the torque converter and gearbox. Torque all bolts to specifications.
6. Fill the automatic transmission with fresh oil. The oil level must be adjusted according to the instructions in the owner’s manual.
Adviсe:
* Use only high quality oil seal from a reputable manufacturer.
* Before installing a new oil seal, clean the sealing surface.
* Do not over-tighten the bolts when assembling the transmission.
* After repairs, run the car in to check the tightness and operation of the automatic transmission.