Materials:
* 10 mm socket wrench
* Flat blade screwdriver
Instructions:
1. Disconnect the negative terminal of the battery.
2. Remove the front trim of the center console. Pull the bottom of the cover towards you and disconnect it from the side latches.
3. Remove the two Torx screws under the front trim. Use a flat blade screwdriver to pry up the trim at two points and remove the screws.
4. Disconnect the wiring. Disconnect the wiring connector from the rear of the shifter.
5. Pull the automatic transmission selector up and towards you. The selector will be held in place by a latch.
6. Remove the selector. Pull the selector all the way up and remove it from the hole.
Adviсe:
* Be careful not to damage the wiring when removing the selector.
* When installing a new automatic transmission selector, make sure that all latches are locked and the wiring is securely connected.
* Reset the adaptive settings of the automatic transmission after installing a new selector.