Tools:
* Phillips screwdriver
* Flathead screwdriver or spatula for opening
Instructions:
1. Disconnect the battery:
* Loosen the nut on the negative battery terminal and remove the cable.
* Push the protective cap onto the terminal.
2. Remove the protective panel:
* Remove the bezel around the gear selector using a flathead screwdriver or spudger.
* Pry up the protective panel above the gear selector and remove it.
3. Disconnect the electrical connector:
* Locate the electrical connector connected to the gear selector.
* Press the latch and disconnect the connector.
4. Remove the cables:
*Locate the two cables attached to the gear selector.
* Press the plastic clips on the cables and disconnect them.
5. Unscrew the bolts:
* Locate the four bolts securing the gear selector to the console.
* Loosen the bolts with a Phillips screwdriver, but do not remove them completely.
6. Remove the gear selector:
* Lift the rear of the gear selector and remove it by pulling it towards you.
Adviсe:
* When disconnecting cables, be careful not to damage them.
* Remember to disconnect the battery to avoid short circuit.
* To install the gear selector, follow the steps in reverse order.