Necessary materials for replacing the Mitsubishi Outlander automatic transmission pan gasket:
* New automatic transmission pan gasket
* Automatic transmission fluid (about 5 liters)
* Automatic transmission oil filter (if necessary)
* Oil pan drain plug gasket
* Gasket sealant (recommended)
* Set of wrenches and socket heads
* Container for collecting waste liquid
The process of replacing the Mitsubishi Outlander automatic transmission pan gasket:
1. Prepare the vehicle: Park the vehicle on a level surface and install wheel chocks.
2. Drain the automatic transmission fluid: Place a container under the oil pan drain plug and unscrew the plug. Drain the automatic transmission fluid into a container. Install a new gasket on the drain plug.
3. Unscrew the automatic transmission pan bolts: Loosen the bolts around the perimeter of the automatic transmission pan, but do not unscrew them completely.
4. Press out the automatic transmission pan: Using a crowbar or flat-head screwdriver, carefully press the automatic transmission pan from the automatic transmission housing. The tray may be glued with sealant, so some force will be required.
5. Remove the old gasket: Remove the old gasket from the pan and automatic transmission housing. Thoroughly clean both surfaces of any old gasket and sealant residue.
6. Install a new gasket: Apply a thin layer of gasket sealant to the pan and transmission housing around the perimeter. Install the new gasket in place.
7. Reinstall the automatic transmission pan: Place the automatic transmission pan on the automatic transmission housing and tighten the bolts by hand. Then tighten the bolts completely using a torque wrench in the order specified in the repair manual.
8. Fill the automatic transmission fluid: Fill the automatic transmission with new fluid through the filler hole. The volume of liquid to be filled depends on the car model. Use a funnel to avoid spilling.
9. Check the automatic transmission fluid level: Start the engine and let it warm up to operating temperature. Switch the automatic transmission selector to all positions and return to the parking position. Check the automatic transmission fluid level using the dipstick. Add fluid if necessary.
10. Reset the automatic transmission fluid aging counter: Connect the OBDII scanner to the diagnostic port and follow the instructions to reset the automatic transmission fluid aging counter.
Adviсe:
* Use only original or high quality spare parts.
* Make sure the pan gasket and oil filter are installed correctly.
*Tighten the pan bolts to the recommended torque.
* Check the automatic transmission fluid level after driving several kilometers.