Tools and materials required to replace the automatic transmission pan gasket on a Mazda Familia:
* Automatic transmission pan gasket
* Automatic transmission pan
*ATF oil
* Drain plug with gasket
* Automatic transmission sealant
* Wrench set
* Rags
*Measuring cup or funnel
*Gloves (recommended)
* Oil drain pan
Instructions for replacing the automatic transmission pan gasket on a Mazda Familia:
1. Precautions:
* Make sure the vehicle is on a level surface and the parking brake is set.
*Wait until the engine and transmission have cooled down.
* Wear gloves to protect from hot oil.
2. Drain ATF oil:
* Locate the drain hole at the bottom of the automatic transmission pan.
* Place an oil drain pan under the drain hole.
* Loosen the drain plug using a wrench and remove it.
* Drain the ATF oil into the pan.
* Screw on the drain plug and tighten it with a gasket.
3. Removing the automatic transmission pan:
* Locate the transmission pan mounting bolts around the edges of the pan.
* Loosen the bolts using a wrench.
* Carefully remove the pan from the automatic transmission housing.
* Remove the old gasket and clean the mating surfaces of the pan and automatic transmission housing from old sealant and debris.
4. Installing a new gasket:
* Apply a thin layer of automatic transmission sealant to the mating surface of the pan.
* Install a new gasket on the automatic transmission pan.
5. Installing the automatic transmission pan:
* Lift the automatic transmission pan and align it with the automatic transmission housing.
*Insert the mounting bolts and tighten them with a wrench.
6. Filling with ATF oil:
* Pour new ATF oil into the hole of the automatic transmission dipstick.
*Use a measuring cup or funnel to accurately measure the amount of oil you add.
* Check the oil level using the automatic transmission dipstick until it reaches the “Max” mark.
7. Leak test:
* Start the engine and let it run for a few minutes.
* Check under the car for oil leaks.
8. Resetting automatic transmission adaptation values (if necessary):
* If any electrical connectors of the automatic transmission were disconnected during the repair, it may be necessary to reset the automatic transmission adaptation values.
*Refer to your specific vehicle’s repair manual for instructions on resetting adaptation values.