Checking the automatic transmission oil level
Required tools:
* Automatic transmission dipstick
* Set of keys (if necessary)
Instructions:
1. Warm up the engine and automatic transmission: Start the engine and drive for about 10-15 minutes so that the transmission oil warms up to operating temperature.
2. Park the vehicle on a level surface: This will ensure an accurate measurement of the oil level.
3. Turn off the engine: Apply the parking brake to the vehicle.
4. Find the automatic transmission dipstick: It is usually located on the side of the automatic transmission.
5. Remove the dipstick: Pull the dipstick handle and wipe it with a clean cloth.
6. Reinsert the dipstick: Insert the dipstick completely back into the tube and pull it out again.
7. Check the oil level: Depending on the model, there may be two marks on the dipstick: “HOT” (hot) and “COLD” (cold). Check the oil level at the “HOT” mark, as measurements are usually taken at operating temperature.
8. The level must be between the “HOT” marks: If the level is below the “HOT” mark, it is necessary to add oil. If the level is above the “HOT” mark, it must be drained.
Topping up automatic transmission oil:
1. If the oil level is low, locate the plug on the automatic transmission pan.
2. Unscrew the plug using a set of keys.
3. Using a funnel, carefully add the transmission oil recommended by the manufacturer into the automatic transmission.
4. Add oil until the level reaches the “HOT” mark on the dipstick.
5. Tighten the automatic transmission pan plug.
Draining automatic transmission oil:
1. If the oil level is high, locate the drain plug on the automatic transmission pan.
2. Place a container under the oil pan.
3. Unscrew the drain plug and drain the oil.
4. When the oil stops flowing, tighten the drain plug.
5. Check the oil level on the dipstick and add if necessary.