Materials:
* Oil for automatic transmission Toyota WS (about 4 liters)
* Automatic transmission pan gasket
* Automatic transmission filter (if required)
* Funnel
*Clean rag or paper towels
Tools:
* Wrench set or wrench
* Lift or jacks and supports
* Oil drain container
* Torque wrench
Instructions:
1. Preparation:
* Place the vehicle on a lift or raise it using jacks and stands.
* Make sure the engine is off and the transmission is in park.
2. Draining the oil:
* Locate the automatic transmission pan located under the vehicle.
* Place a container to drain the oil under the pan.
* Remove the bolts on the pan pan using a wrench or wrench.
* Allow the oil to drain completely into the container.
3. Replacing the gasket and filter (if necessary):
* Remove the old automatic transmission pan and gasket.
* Replace the gasket with a new one.
* If you need to replace the automatic transmission filter, remove the old filter and install a new one.
4. Installing the automatic transmission pan:
* Reinstall the transmission pan and tighten the bolts using a torque wrench to Toyota specifications.
5. Filling oil:
* Using a funnel, pour new oil into the automatic transmission through the dipstick hole.
*Add about 3 liters of oil.
6. Checking the oil level:
* Start the engine and let it idle.
* Shift the transmission to all positions and return to the park position.
* Remove the automatic transmission dipstick and check the oil level. The level should be between the “min” and “max” marks on the dipstick.
*Add oil if necessary.
7. Resetting the automatic transmission oil top-up counter:
* After changing the oil, you must reset the automatic transmission oil refill counter. To do this, connect the OBD2 diagnostic scanner to the car and follow the instructions.
8. Final check:
* Check the car for oil leaks.
* Drive the car to check its operation.