Materials:
* Automatic transmission oil LR033900 (about 4 liters)
* Automatic transmission oil filter LR033050
* Automatic transmission oil sump gasket LR009096
* O-ring for automatic transmission drain plug N90476701
* 17 mm hex key
* Funnel with thin spout
* Oil collector
Instructions:
Preparatory work
* Raise the car on a lift or place it on supports.
* Start the engine and let it idle for a few minutes to warm up the automatic transmission oil.
* Stop the engine.
Partial oil change
1. Place an oil collector under the automatic transmission drain plug.
2. Unscrew the drain plug with a 17 mm hex key. Drain the oil into a collection container.
3. Install a new sealing washer on the drain plug and screw the plug back on.
4. Remove the automatic transmission oil pan by unscrewing the fastening bolts.
5. Remove the oil filter and clean the pan of dirt and chips.
6. Install a new oil filter and oil pan gasket.
7. Reinstall the oil pan and tighten the bolts.
8. Fill new automatic transmission oil into the gearbox through the dipstick hole. Focus on the level using the dipstick (hot level).
9. Start the engine and let it idle.
10. Check the oil level on the dipstick and add if necessary.
Adviсe:
* Repeat partial oil changes every 50,000-60,000 km.
* If the oil is heavily contaminated or has a burning smell, it is recommended to completely change the automatic transmission oil.
* Dispose of used oil and parts according to local regulations.