Materials:
* Gearbox
* Transmission fluid
* New oil filter
* Oil pan gasket
* New transmission mounting bolts
* Sealant for oil pan gasket
* Tools:
* Wrenches
* Collar
* Socket heads
* Screwdriver
* Jack and supports
Installation procedure:
1. Prepare the vehicle: Raise the vehicle and secure it on supports. Drain the transmission fluid from the gearbox.
2. Disconnect the drive shafts: Remove the rubber boots from the CV joints of the drive shafts. Unscrew the nuts securing the shafts to the gearbox flanges and knock them out using a hammer and mandrel.
3. Disconnect the starter: Unscrew the starter mounting bolts and disconnect it from the gearbox.
4. Disconnect Sensors and Wiring: Disconnect all electrical connectors and sensors from the transmission.
5. Remove the transmission mounting bolts: Loosen and remove all transmission mounting bolts to the engine and mounts.
6. Disconnect the oil pan: Using a screwdriver, pry up and remove the transmission oil pan. Replace the pan gasket with a new one.
7. Install the new oil filter: Screw the new oil filter into place.
8. Install the Transmission: Carefully push the transmission into place, aligning it with the engine and mounts.
9. Tighten the transmission mounting bolts: Tighten the transmission mounting bolts to the specified torque.
10. Connect the oil pan: Reinstall the oil pan and tighten the oil pan bolts. Apply sealant to the pan gasket.
11. Connect the drive shafts: Insert the drive shafts into the appropriate flanges on the transmission. Tighten the shaft nuts.
12. Connect the starter: Reinstall the starter and tighten its mounting bolts.
13. Connect Sensors and Wiring: Reconnect any previously disconnected electrical connectors and sensors to the transmission.
14. Fill transmission fluid: Fill the transmission with new transmission fluid to the required level.
15. Lower the vehicle: Lower the vehicle from the supports.
16. Check the operation of the gearbox: Start the engine and check the operation of the gearbox in all gears.
17. Check the transmission fluid level: After a short drive, check the transmission fluid level again and add if necessary.