Required materials:
* LED strip
* Scissors
* Electrical tape
* Heat shrink tubing
* Connection terminals
Instructions:
1. Disconnect the battery: Disconnect the negative terminal of the battery for safety.
2. Remove the transmission cover: Grasp the transmission cover and gently pull it up to remove it.
3. Clean the surface: Clean the surface of the automatic transmission casing on which the LED strip will be installed with alcohol or degreaser.
4. Cut the LED strip: Cut the LED strip to the required length to match the contours of the automatic transmission housing.
5. Peel off the protective layer: Remove the protective layer from the LED strip to expose the adhesive side.
6. Attach the LED strip: Attach the LED strip to the automatic transmission casing, pressing it gently.
7. Make connections: Connect the LED strip to the power source using the connection terminals. Make sure the polarity of the connections is correct.
8. Insulate connections: Insulate connections with heat shrink tubing or electrical tape to prevent short circuits.
9. Reinstall the transmission cover: Carefully push the transmission cover back into place, pressing until it locks into place.
10. Connect the battery: Reconnect the negative terminal of the battery.
Adviсe:
*Use waterproof LED strip to prevent water damage.
* Place the LED strip so that it does not interfere with the operation of the automatic transmission controls.
*Check all connections before connecting the battery.
*If you are unsure of your skills, seek help from a professional electrician.