Required tools and materials:
* Side cutters
* Phillips screwdriver
* Flat head screwdriver
* Mounting hook
* New O-ring kit (recommended)
* Cleaning solvent (such as carburetor cleaner)
* Transmission Lubricant
* Rags
Repair steps:
1. Removing the gear selector
* Disconnect the battery.
* Remove the center console and gearshift frame.
* Locate the shift cable connected to the selector.
* Disconnect the cable from the selector.
*Remove the obsolete selector assembly.
2. Disassembling the selector
* Turn the selector upside down.
* Remove the screws holding the selector housing.
* Carefully separate the selector housing.
3. Cleaning and inspection
* Clean all selector components with cleaning solvent.
* Check all parts for damage or wear.
* Replace damaged or worn parts as necessary.
4. Replacing O-rings
*If new O-rings are used, apply transmission lube to the new O-rings.
* Remove the old O-rings using the mounting hook.
* Install new O-rings into the grooves.
5. Assembly and installation of the selector
* Assemble the selector housing by aligning its halves.
* Install the screws and tighten them.
* Connect the shift cable to the selector.
* Reinstall the selector assembly.
* Install the center console and shift frame.
6. Cable connection and testing
* Connect the battery.
* Check the operation of the selector by changing gears.
* Make sure shifting is smooth and precise.
7. Final adjustments
*If shifting does not occur as expected, further adjustment of the shift cable may be required.
*Adjust the cable to ensure proper travel and eliminate shifting problems.