Transmission compartment
* Remove the oil pan by unscrewing all the mounting bolts.
* Unscrew the nuts securing the flange to the torque converter.
* Place a stand under the gearbox housing.
* Disconnect the gearbox housing from the engine by unscrewing the mounting bolts.
* Raise the engine with a jack.
* Remove the gearbox.
Disassembling the differential
* Secure the differential using a special tool or by holding it in a vice.
* Unscrew the differential housing mounting bolts.
* Remove the differential cover.
* Remove the differential axle along with the bearings.
Removing bearings
*Use a bearing puller or drift to remove the bearings from the differential axle.
* Be careful not to damage the axle or bearings.
Installing new bearings
* Install new bearings onto the differential axle using a drift or bearing puller.
* Press in the bearings until they stop.
Differential assembly
* Install the differential axle with new bearings into the differential housing.
* Install the differential cover and tighten the mounting bolts.
Gearbox Assembly
* Connect the gearbox housing to the engine and tighten the mounting bolts.
* Lower the engine.
* Install the oil pan and tighten the mounting bolts.
* Connect the flange to the torque converter and tighten the mounting nuts.
* Install the gearbox on the car.
Other tips
*Before installing new bearings, check the differential axle for wear or damage.
* When replacing bearings, it is advisable to use original spare parts or high-quality analogues.
* Ensure proper clearance between bearings and axle.
* Make sure the mounting bolts are tightened to the specified torque.
* After assembling the gearbox, check the oil level and add it if necessary.