Adaptation of automatic transmission Subaru Forester SG5
Automatic transmission adaptation for Subaru Forester SG5 is the process of tuning the automatic transmission to ensure optimal performance. It is necessary after certain maintenance or repairs, such as:
* Changing automatic transmission oil
* Replacing the automatic transmission filter
* Automatic transmission repair
Materials:
* OBDII scanner
* Software for automatic transmission adaptation (for example, Subaru Select Monitor)
Procedure:
1. Connect the scanner
Connect the OBDII scanner to the vehicle’s diagnostic connector.
2. Launch the software
Run the automatic transmission adaptation software on your computer.
3. Select your car model
Select the Subaru Forester SG5 model from the list of supported vehicles.
4. Establish communication with the automatic transmission ECU
Establish communication between the computer and the automatic transmission ECU.
5. Select onboarding procedure
Select the ‘Automatic Transmission Adaptation’ procedure from the list of available options.
6. Start onboarding
Follow the onscreen instructions to begin the onboarding process.
7. Follow directions
During the onboarding process, you will be asked to complete a number of actions, such as:
* Switch the gear selector lever to different positions
*Hold the brake pedal
* Give engine speed
8. Completion of adaptation
The onboarding process usually takes a few minutes. Once the procedure is completed, a message indicating its success will appear on the screen.
9. Clearing fault codes
After adapting the automatic transmission, clear any fault codes that may have arisen during the procedure.
10. Take a test drive
Perform a short test drive to ensure that the automatic transmission operates properly.
Notes:
* Always use original automatic transmission oil recommended by the manufacturer.
* Make sure the automatic transmission oil level is correct.
* If any problems occur after adapting the automatic transmission, contact a qualified mechanic.