Toyota Automatic Transmission Manual
Introduction
Toyota’s automatic transmission (AT) is designed to provide smooth and efficient gear changes. It is designed using advanced technologies to provide optimum performance and fuel efficiency.
Operating modes
*P (Park): Locks the transmission to park the vehicle.
* R (Reverse): Engages reverse gear.
* N (Neutral): Disconnects the transmission from the engine, allowing the vehicle to roll freely.
* D (Drive): Normal driving mode that automatically changes gears depending on speed and load.
*S (Sport): Holds lower gears for improved engine acceleration and braking.
* L (Low): Used for steep grades, towing or off-road driving.
Gear shift position
The location of the gear shift lever may vary depending on the vehicle model. It is usually located on the center console or steering column.
Gear shift control
To change gears, follow these steps:
1. Press the lock button on the shift lever (if equipped).
2. Move the lever to the desired position.
3. Release the lock button (if equipped).
Maintenance Tips
To maintain optimal automatic transmission performance, follow these recommendations:
* Check the transmission fluid level regularly and top up if necessary.
* Change transmission fluid and filter according to your maintenance schedule.
* Avoid sudden acceleration and braking.
* Do not tow loads that exceed the permissible weight.
Warnings
* Do not attempt to change gears while driving unless absolutely necessary.
* Do not use the N position for extended driving as this may cause the transmission to overheat.
*If you notice any unusual noises or vibrations while the automatic transmission is operating, contact a certified mechanic.
By following these operating instructions and maintenance tips, you can ensure long, reliable service from your Toyota automatic transmission.