Automatic transmission selector illumination Toyota RAV4
Required tools:
* Set of screwdrivers (flat and Phillips)
* Plastic prying tool
* New LED (2835 SMD)
Procedure:
1. Disconnect the battery
Disconnect the negative terminal of the battery to prevent a short circuit.
2. Remove the center console
* Carefully pry up the plastic panel around the automatic transmission selector using a plastic prying tool.
* Disconnect the connectors going to the panel.
* Remove the screws securing the center console to the dashboard.
* Lift and remove the center console.
3. Remove the automatic transmission selector housing
* Unscrew the screws securing the automatic transmission selector housing.
* Carefully remove the cover.
4. Replace LED
* Find the LED that is responsible for illuminating the automatic transmission selector.
*Use a flathead screwdriver to carefully pry and remove the LED.
* Insert the new LED into place, observing the correct polarity (+ to +, – to -).
5. Reassemble everything in reverse order
* Reinstall the automatic transmission selector housing and tighten the screws.
* Install the center console and tighten the screws.
* Connect the connectors to the panel around the automatic transmission selector.
* Click the plastic panel back into place.
6. Connect the battery
Connect the negative terminal of the battery.
Examination:
* Turn on the headlights and check if the automatic transmission selector light is on.
Adviсe:
*Make sure you purchase the correct LED.
* Be careful when removing and installing plastic parts to avoid breaking them.
*If you experience difficulty, consult your vehicle’s repair manual or a qualified mechanic.