Peugeot 206 automatic transmission shift cable
Replacing an automatic transmission shift cable on a Peugeot 206
Tools and materials:
* New automatic transmission shift cable
* 13mm wrench
* 17mm wrench
* Mounting lever (optional)
*WD-40 or other penetrating lubricant
Instructions:
1. Secure the car.
* Stop the engine.
* Set the car to the parking brake.
* Disconnect the negative terminal of the battery.
2. Disconnect the cable from the gear selector.
* Press the lock button on the gear shift knob and move the lever to the ‘Park’ position.
*Locate the two 13mm bolts that secure the cable to the gear selector.
* Unscrew the bolts and disconnect the cable.
3. Disconnect the cable from the gearbox.
* Raise the vehicle on a lift or use jacks and stands.
*Locate the two 17mm bolts on the gearbox that secure the cable.
* Unscrew the bolts and disconnect the cable.
4. Remove the old cable.
* Pull the old cable out of the fastenings and move it to the side.
5. Install a new cable.
* Insert the new cable into the fasteners.
* Place a new cable on the gear selector and on the gearbox.
* Tighten the mounting bolts to 20 Nm.
6. Adjust the cable.
* The gear selector must be in the ‘Park’ position.
* The cable must be adjusted so that there is no rubbing when changing gears and the tension is sufficient.
* To adjust, use the mounting lever or manually pull the cable and secure the position with bolts.
7. Connect the battery.
* Connect the negative terminal of the battery.
8. Check the work.
* Start the engine and change gears to check for proper operation.
Adviсe:
* Before installing a new cable, apply lubricant to prevent it from seizing.
*If you have difficulty adjusting the cable, consult an experienced mechanic.