Self-diagnosis of automatic transmission on Nissan Cefiro

Note: These instructions are for Nissan Cefiro vehicles manufactured before 2004. Newer models may require different procedures.

Materials:

* Paperclip or wire
* Rag or paper

Instructions:

1. Warm up the engine: Start the engine and let it idle for a few minutes until it reaches operating temperature.

2. Turn off the engine: Turn off the engine and remove the key from the ignition.

3. Locate the diagnostic connector: The diagnostic connector is usually located under the dashboard on the driver’s side. It can be closed with a panel or a lid.

4. Connect the paperclip: Straighten the paperclip and insert one end (approximately 1 cm) into the diagnostic socket. The other end should touch the DLC (Data Link Connector) pin.

5. Insert the key into the ignition: Do not turn the key.

6. Observe the Check Engine Light Flashing: The Check Engine Light will begin flashing trouble codes.

7. Count the blinks: Record the number of blinks for each code. The codes consist of two separate flashing sequences:

* Short flashes: Indicates the first digit of the code.
* Long flashes: Indicates the second digit of the code.

8. Read all codes: Repeat steps 4-6 until all codes have been read.

Example:

* 5 short flashes then 2 long flashes = Code 52
* 3 short flashes then 1 long flash = Code 31

Reset codes:

Once the fault codes have been read, they can be reset as follows:

1. Remove the paper clip from the diagnostic connector.
2. Start the engine.
3. Let the engine idle for several minutes.
4. Turn off the engine.

Decoding codes:

Fault codes for Nissan Cefiro automatic transmission can be found in the vehicle repair manual or on various websites.

Notes:

*If the Check Engine Light flashes quickly and continuously, it indicates a serious problem and requires immediate attention.
*If no codes are displayed when the Check Engine light is flashing, there may be no codes stored in the trouble memory.
* For more accurate diagnosis and repair, it is recommended to contact a qualified specialist.

Leave a Reply