Adjusting the automatic transmission shift cable
Required tools:
* Set of keys
* Flat head screwdriver
Steps:
1. Find the automatic transmission shift cable
* It is usually located near the engine or transmission.
2. Loosen the nut on the bracket
* Locate the bracket that secures the cable to the transmission.
*Use a wrench to loosen the nut on the bracket, but do not remove it completely.
3. Place the gear shift lever in neutral position
* Enter the vehicle and move the gear shift lever to neutral.
4. Adjust cable slack
* Check if there is any clearance between the nut and the bracket.
* Use a flathead screwdriver to adjust the cable slack, moving the nut up or down as needed.
* Leave about 1-2 mm of free play on the cable.
5. Tighten the nut
*Once you have adjusted the cable slack correctly, tighten the nut on the bracket with a wrench.
6. Check for proper operation
* Get into the car and start the engine.
* Move the gearshift lever through all gears and check whether the gears shift smoothly.
7.Re-adjust if necessary
*If gears do not shift smoothly, repeat steps 3-6 until proper operation is achieved.
Adviсe:
* Check the oil level in the automatic transmission before adjusting the cable.
*If you experience any difficulties, consult a qualified mechanic.
*Transmission shift cable adjustment is an important task that can affect transmission performance and longevity.