Tools and materials:
* Screwdriver set
* Wrench set
* Nippers and strippers
* Soldering iron and solder
* Heat shrink tubing
* Electrical tape
* Wires and connectors
* Multimeter
* Check light
* Torque wrench (recommended)
Assembly steps:
1. Removing old wiring
* Disconnect the car battery.
* Remove all electrical components (headlights, lights, relays, switches, etc.).
* Remove old wiring by cutting it into manageable sections.
2. Preparing new wiring
* Determine and measure the required length of new wires.
*Cut, strip and solder the appropriate terminals to each wire.
* Install heat shrink tubing over exposed terminals and apply heat to protect them.
3. Installation of new wiring
* Pull the new wiring through the conduits and harnesses using plastic ties or tape to secure them.
*Connect the wires to the appropriate terminals and tighten the screws using a torque wrench (if equipped).
* Install new electrical components.
4. Assembling wiring harnesses
* Gather the wires into organized bundles using plastic ties.
* Wrap electrical tape around the harnesses for protection.
5. Connection to battery
*Connect the positive battery cable to the “+” terminal on the battery.
*Connect the negative battery cable to the “-” terminal on the battery.
6. Testing and diagnostics
*Install the battery and check the wiring connection with a multimeter.
* Turn on the headlights and other electrical components to check their functionality.
* If any problems are found, carefully check the connections and wires for damage.
Adviсe:
* Use wires of the correct size and use crimp terminals for reliable connections.
* Ensure that the wires are well protected from damage and moisture.
* Connections must be soldered and insulated with heat shrink tubing.
* Label wires for easy identification.
*If you experience any difficulties, please contact a qualified electrician for assistance.