Step 1: Warm up the engine.
Start the engine and let it idle for about 10 minutes to allow the transmission fluid to reach operating temperature.
Step 2: Shift through all gears.
Without leaving the vehicle, shift through all gears, including reverse, and return to Park (P). This will ensure fluid circulation throughout the system.
Step 3: Check the fluid level.
* Pull the hood and open it while holding it with a stand.
* Find the automatic transmission fluid dipstick. It usually has a red or orange handle and is located in the rear of the engine compartment.
* Remove the dipstick and wipe it with a clean cloth or paper towel.
* Insert the dipstick back and remove it again.
* The fluid level should be between the two marks on the dipstick – “HOT” (hot) and “ADD” (add).
Step 4: Add liquid if necessary.
If the fluid level is below the “ADD” line, you need to add fluid.
*Use a funnel to carefully add transmission fluid through the dipstick hole.
*Add a small amount of liquid at a time and check the level after each addition.
* Make sure the fluid level is between the “HOT” and “ADD” marks.
*Do not overfill.
Step 5: Reset the automatic transmission fluid aging counter (if applicable).
Some Honda models have an automatic transmission fluid aging counter. After servicing the fluid, the meter must be reset to ensure an accurate reading of the remaining fluid life. Refer to your owner’s manual for specific instructions on how to reset the counter.
When checking the Honda automatic transmission fluid level, keep the following points in mind:
* Check the fluid only when the engine is warm.
*Use the automatic transmission fluid recommended by Honda for your vehicle.
* Monitor the automatic transmission system for leaks or damage.
* Change the automatic transmission fluid regularly in accordance with the manufacturer’s recommendations.