Steps to install automatic transmission:
1. Collection of necessary materials:
*Automatic transmission compatible with your car
* Transmission fluid
* Transmission filter
* Sealant for transmission housing gasket
* Set of tools and consumables
2. Preparing the car:
* Raise the vehicle on jack stands or use a lift.
* Drain the oil from the gearbox.
* Disconnect the driveshaft.
3. Removing the old gearbox:
* Disconnect all electrical connectors and cooling lines.
* Remove the bolts securing the gearbox to the engine and mounts.
* Carefully lower the old gearbox.
4. Installing a new gearbox:
* Lift the new gearbox into place.
* Bolt it to the engine and mounts.
5. Connecting communications:
* Connect the driveshaft.
* Repair all electrical connectors and cooling lines.
* Make sure all bolts and connections are securely tightened.
6. Replacing the filter and fluid:
* Replace the transmission filter.
*Pour new transmission fluid into the transmission according to manufacturer specifications.
7. Installing the oil pan:
* Apply sealant to the oil pan gasket.
* Reinstall the oil pan.
* Tighten the oil pan mounting bolts.
8.Complete installation:
* Lower the vehicle from the lift or racks.
* Clean up any transmission fluid leaks.
* Check the gearbox fluid level and top up if necessary.
Notes:
*Proper installation requires special equipment and experience.
* Before starting work, read the service manual for your vehicle.
* It is recommended that you consult a qualified mechanic to perform this task.
* After installation, test drive to check the operation and smooth shifting of the gears.