Materials:
* Washing machine
* Electrical cord with three-wire plug
* Wire terminals (wires)
* Screwdriver or screwdriver
Security measures:
*Be sure to turn off the electrical power before starting work.
* Insulate all electrical connections with electrical tape or heat shrink tubing.
* Make sure the washing machine is properly grounded.
Instructions:
1. Open the back panel of the washing machine:
* Locate and remove the screws that hold the back panel in place.
* Carefully remove the back panel.
2. Prepare the electrical cord:
*Cut the wire to the required length.
* Strip the insulation from the ends of the wires by about 1.5-2 cm.
* Bend the bare ends of the wires into hooks.
3. Connect the wires to the terminals of the washing machine:
* Identify the terminals for the wires on the washing machine:
* L (line) – usually red or brown
* N (neutral) – usually white or blue
* PE (ground) – usually yellow or green with a yellow stripe
*Connect the hook wire to the corresponding terminal:
* Red or brown wire to terminal L
* White or blue wire to terminal N
*Yellow or green wire to PE terminal
4. Tighten the terminals:
*Using a screwdriver or screwdriver, tighten the screws on the terminals to securely secure the wires.
5. Reinstall the back panel:
* Install the back panel on the washing machine.
* Tighten the screws to secure it.
6. Connect the plug to the outlet:
* Connect the plug to a grounded outlet.
7. Turn on the power and check the washing machine:
* Turn on the power supply.
* Turn on your washing machine and run a wash cycle to make sure it is working properly.